what size hardie trim around windowspolyblend vs polyblend plus grout
Days before your small window project starts, make sure to have all the tools and supplies. Cut the hardie plank to the appropriate width with a circular saw. Now that youve installed the Hardie siding around your windows, youll want to make sure theyre flashed properly. He is worried 4.5" is too big for the house. An apron can be added to replicate an old-style window trim, as well as the ever popular craftsman by picture framing the opening in widths ranging from 2 to 5 inches. You're now a First Fridays Insider. With James Hardie's range of Window Trims, give your window and door frames a perfect finishing touch. The trim is installed around the window and helps to give it a finished look. When the cladding around the window is a flat sheet, the cladding can either be butted to the Hardie TM Axent Trim as shown in Figure 1 OR installed overlapping the Hardie TM Axent Trim. Windows measuring 3-feet x 4-feet and smaller will use 1/4-inch lag screws, 2-1/2-inches long. Heres what he had to say: Excellent job. Use a level to ensure that the hardie trim is straight, Measure the window trim and cut the hardie trim to the appropriate size, Apply construction adhesive to the back of the trim Its up to you whether you want to remove your old trim or not. Hi, Im Nick! Installing Hardie trim around windows is a fairly simple process. Also, should the apron under the sill be the same width as the sides/header? JamesHardie Trim Installation - YouTube About Us - Contact Us - Privacy Policy - Disclaimer. A: JLC Staff respond s: The trick to installing exterior flat-stock trim around a flanged window is having the trim sit flat (in plane with the wall) while the trim's outer face is proud of the siding for aesthetic reasons. Installation | Resource Center | James Hardie Ready for real inspiration? When adding the flashing, do so in horizontal and vertical directions to give the most thorough protection you can. Any thoughts? 0000005298 00000 n All the exposed edges should be eased (rounded a bit), and cuts should be clean and free of chipping. Cutting siding with those items using a circular saw generates an intensive loud noise. This means that all your trims will have to be painted at a local paint shop, or on sawhorses at the jobsite. By no means do you have to remove your old trim, but in the event you do, I wanted to include it. 2. No matter how you decide to install Hardie siding around your windows and doors, make sure that your openings are flashed correctly, not just according to James Hardies installation instructions, but to your local building code.